This year marks ten years. The plant is a 7,000 m² wire manufacturing facility in the Muradiye Organized Industrial Zone (Muradiye OSB), Manisa. Under one roof we run wire rod receiving, cold drawing, annealing, cut-to-length, flat-bar profiling, and packaging. That single-site…
Wire rod incoming inspection — the earliest quality decision we make
Every coil of wire rod that arrives at Muradiye OSB gets inspected before it enters our drawing bays. We check the mill certificate, cross-check hardness ourselves, and log any surface finding. It sounds obvious. But the earlier you catch a rod-quality…
An appliance customer standardises on one wire supplier
A long-time white-goods customer moved this year to a single-source arrangement on the wire grades we produce for their oven grill assemblies. The rationale on their side: tensile scatter between shipments from multiple vendors was creating downstream setup problems on their…
Automotive and appliance demand — 2014 outlook
Automotive sub-supply and white-goods manufacturing both continue to pull cold-drawn wire in 2014. Tensile tolerance keeps tightening. Construction demand stays strong. Cold-drawn low-carbon wire for mesh and fasteners is a growing line for our plant. Our production planning is now built…
EN 10204 3.1 inspection certificates — why we default to them in 2014
EN 10204 3.1 is a “specific inspection document” — validated by our inspection department, independent of the production line — that certifies the material meets ordered specification and gives real test results from the actual heat. In 2014 it is treated…
Construction and mesh: quiet volume that respects the calendar
Construction wire — cold-drawn for mesh, fastener stock, hot-dip galvanising feedstock — is our stability product. Volumes rise when construction rises, and they respect the calendar. In 2014, buyers in the region and in export markets (EU, MENA) are asking for…
Annealed wire that arrives soft, clean and ready to form
Our annealed wire line runs in 2014 on inter-annealed and full-annealed cycles depending on the customer’s tensile target. Coating-ready surface is standard. Because we anneal in-house, we can respond quickly when a customer says “same grade, softer, ship this week.” That…
Looking back on 2013 — production, customers, and what changed (2013)
2013 brought steady demand across our end sectors and continued expectation on documentation quality. Turkey’s appliance sector is booming. Buyers are consolidating vendors and demanding EN 10204 3.1 certificates by default. We exported to Europe, the Middle East and North Africa….
DIN EN 10016 — wire rod for cold drawing and cold rolling (2013)
DIN EN 10016 covers wire rod for cold drawing and cold rolling. It defines the chemistry and surface expectations of the rod we buy from mill partners. In 2013 we hold our mill partners to 10016 as the incoming rod baseline….
Export destinations — where our wire is going in 2013 (2013)
In 2013 our export mix is: Europe, the Middle East and North Africa. Different destinations have different documentation expectations. Every export shipment travels with an EN 10204 3.1 inspection certificate and a commercial pack that includes packing list, invoice, and country-of-origin…