This year marks eighteen years. The plant is a 7,000 m² wire manufacturing facility in the Muradiye Organized Industrial Zone (Muradiye OSB), Manisa. Under one roof we run wire rod receiving, cold drawing, annealing, cut-to-length, flat-bar profiling, and packaging. That single-site…
Wire rod incoming inspection — the earliest quality decision we make
Every coil of wire rod that arrives at Muradiye OSB gets inspected before it enters our drawing bays. We check the mill certificate, cross-check hardness ourselves, and log any surface finding. It sounds obvious. But the earlier you catch a rod-quality…
A condenser wire customer expands their cold-chain business
Cold-chain refrigeration continues to grow as an end-sector for our condenser (bundy-tube grade) wire. A customer in the cold-chain space expanded their line and needed a step-up in supply. We qualified additional inspection points on the coil surface and adjusted our…
Energy prices, drawing dies, and the cost of a tonne of wire in 2022
2022 pushed European energy prices to levels our industry has not seen in a generation. Every furnace campaign, every drawing pass, every die change has a real cost now. We audited our own electricity per tonne this year — quietly, honestly,…
EN 10204 3.1 inspection certificates — why we default to them in 2022
EN 10204 3.1 is a “specific inspection document” — validated by our inspection department, independent of the production line — that certifies the material meets ordered specification and gives real test results from the actual heat. In 2022 it is treated…
Automotive sub-supply: cold-drawn wire for fasteners
Automotive fasteners rely on cold-drawn low-carbon wire that behaves predictably during header and roll-forming. In 2022 we saw more customers ask for narrower tensile scatter within a single coil, not just batch to batch. To hold that, wire-rod incoming quality control…
Cold-drawn Ø1.00 – Ø14.00 mm — our workhorse family
Cold-drawn wire remains the backbone of what leaves our Muradiye OSB plant in 2022. We draw Ø1.00 to Ø14.00 mm from low-carbon SAE 1006/1008/1010 wire rod, in bright or super-bright finish. Tensile strength typically lands between 500 and 1050 N/mm² depending…
Looking back on 2021 — production, customers, and what changed
2021 brought steady demand across our end sectors and continued expectation on documentation quality. Post-pandemic demand surge collides with a container shortage. Wire buyers want longer confirmed lead times and inventory near their factories. We exported to EU, MENA, Africa, first…
TS EN 10218 — the low-carbon wire family standard we work to
TS EN 10218 covers general requirements for steel wire — low-carbon and higher-carbon grades. It sets tolerances on diameter, tensile, surface, and packaging that we use as the reference for most of our production. In 2021 we treat 10218 as the…
Export destinations — where our wire is going in 2021
In 2021 our export mix is: EU, MENA, Africa, first shipments to the Americas. Different destinations have different documentation expectations. Every export shipment travels with an EN 10204 3.1 inspection certificate and a commercial pack that includes packing list, invoice, and…